| | ||
| |||
| 首頁 關于遠東 產品目錄 銷售網絡 生產設備 公司資質 技術支持 聯系我們 遠東泵業(yè)螺桿泵(包括雙螺桿泵,三螺桿泵,單螺桿泵)檢驗規(guī)則
泵在主要零件材質、制造精度、裝配精度檢驗和液壓試驗合格后，方能進行試運轉。Pump in the major parts material, manufacture, assembly precision accuracy test and hydraulic test after passing the required test run. 泵試驗方法應遵守第６章規(guī)定。Should comply with the requirements of the chapter 6 of the pump test method. 型式檢驗Type of inspection 新產品首制樣機應進行型式檢驗。The first new product prototype should be type test. 系列新產品只對該系列的基本樣機進行型式檢驗；檢驗合格后，比該樣機功率小、排出壓力低的新產品樣機可不做型式檢驗。Series of new products only basic prototype of the series type inspection; After inspection, small power, low exhaust pressure than the prototype of the new product prototype doesn't do type test. 轉廠螺桿泵(包括雙螺桿泵,三螺桿泵,單螺桿泵)應進行型式檢驗Turn factory screw pump (including double screw pump, three screw pump, single screw pump) should conduct pilot test 產品在設計、工藝及材料有重大變化時應做型式檢驗。 In product design, process and material have a major change in type test should be done. 抽查檢驗 Random inspection 成批生產的產品應定期做抽查檢驗。抽查方案按表１０規(guī)定的一次抽樣方案。抽樣時間應均衡地分布在１年中。 Batch production of products should be do random inspection on a regular basis. Selective examination scheme specified in table 10 a sampling plan. Distribution of sampling time should be balanced in 1 year. 抽查檢驗的產品不合格時，應加倍臺數復檢。如仍不合格時，則應逐臺檢驗。 Random inspection of the product is unqualified, it shall reinspect double the Numbers. If it is still not qualified, should by inspection.
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
單螺桿泵包括：
EH(U)系列單螺桿泵、EL單螺桿泵、ER單螺桿泵、ES單螺桿泵、EU單螺桿泵
|
